|
|
|
oOo oOo oOo oOo oOo oOo oOo oOo oOo oOo oOo Please read oOo oOo oOo
|
Humane Restraint - L100 Lock The locking slider of a Humane Restraint locking L100
buckle. If the flat key is inserted into the key slit the pins within the metal
block are raised to the correct height to release the mechanism. On the side of
the metal block you will notice the key hole into which the flat key is
inserted. The photo on the right shows the inner components.
After closing the flap
with the locking pin the metal slider is pushed sideways to prevents the flap
from being opened. On this photo here the slider is pushed half way. A small
button on the edge need to be depressed before the slider can move. This is just
visible in picture 4 on the top edge of the slider. Once the metal block is
completely slid into the locking position (5) the locking pins automatically
engage and prevent the metal slider to be pushed back into the open position.
Below one can see in a sequence of five photos showing how the buckle is closed.
If you pull at the inserted belt the flap stays in the lowered position even without the locking mechanism being engaged. The locking mechanism itself is not under stress because the belt first has to be pushed (tightened) further inwards in order to be able to raise the locking flap. This locking buckle is found on a number of Humane Restraint products. BACK to main HR page |
Send mail to matron@theoriginalinstitute.com with questions or comments about this web site.
Copyright © 2001
The Institute
|
1
2
3
4
5